Basic Info | Proportions(mm) | 29×23.5×16 | |
Bodyweight ( g ) | ≈40g | ||
Speak to Arrangement | 1A/1B | ||
Get in touch with Substance | AgSnO2 | ||
Ambient Temperature | -40~+75ºC | ||
Vibration | 10~50Hz,1.5mm | ||
Shock | 1000m/s²,(100g) | ||
Specs Data | Electricity Intake | <3W | |
Operating Voltage | 10.five-16V | ||
Max. Switching Present | 100A | ||
Surge Current | 6000A/10ms | ||
Motor Resistance | 32(1±15%)Ω | ||
Get in touch with Voltage | <60mV | ||
Get in touch with Resistance | ≤1.0mΩ | ||
Dielectric Toughness | Motor to Get in touch with | >4000VAC,fifty/60Hz 1min | |
Throughout Open Contact | >2000VAC,fifty/60Hz 1min | ||
CZPTal Life(a hundred and twenty cycles/H) | 10,000 (resistance five k + perceptual five k, co ϕ = .5) |
||
Mechanical Daily life(3600 cycles/H) | 100,000 | ||
Pulse Time | ≥60ms(Advise 60ms~100ms) | ||
Selecting-up Time | ≤60ms | ||
Release Time | ≤60ms | ||
Insulation Resistance | >1000MΩ(500VDC) |
Cautions of Latching Relay:
1.Suggestions of relay’s enter
(1)Polarity-Please verify the polarity inside of our complex specification, if one coil then”+ -” or “- +”are fantastic,
you can adjust it by 1 pulse.If double coil then it’s required to verify “-+-” or “+-+”ahead of leaving the our manufacturing unit.
(two)Driving-You should energize the relay at our recommend pulse width, rated voltage for dependable functionality, if one.5
moments or 2 moments of benefit or reduced driving condition plz affirm with our engineer.
(three)Relays’contact position could be modified in the course of transportation or installation thanks to affect of external power,
as a result please reset to the necessary status.
two.Tips of relay’s output
(one)When picking the relay with hard link,make sure you avoid the external power on load terminals in the course of or following
the set up.
(two)When the relay will be connected with screw or bolts to the relays’ terminals, plz make certain your relationship is
fastened and avoid relay from damages or other safety issues owing to temp. Increase..
(3)The sampling sign wires of products are minimal, remember to do not pull or torque in the course of set up.