| Simple Info | Dimension(mm) | 32×35.5×16.five | |
| Weight ( g ) | ≈35g | ||
| Get in touch with Arrangement | 1A/1B | ||
| Speak to Material | AgSnOtwo | ||
| Ambient Temperature | -forty five~+85ºC | ||
| Vibration | ten~50Hz,.075mm | ||
| Shock | 1000m/s²,(100g) | ||
| Specification Data | Nominal Voltage | 9~36VDC | |
| Electricity Intake | <1.5W | ||
| Running Voltage | 7.2V | ||
| Max. Motor Voltage | 36V | ||
| Max. Switching Recent | 90A | ||
| Surge Current | 2500A/10ms | ||
| Motor Resistance(R±15%) | 60Ω | ||
| Get in touch with Voltage | <60mV | ||
| Contact Resistance | <0.6mΩ | ||
| Dielectric Energy | Motor to Make contact with | >4000VAC 1min | |
| Throughout Open Get in touch with | >2000VAC 1min | ||
| CZPTal Life | >10000cycles | ||
| Mechanical Lifestyle | >100000cycles | ||
| Pulse Time | 100ms~150ms | ||
| Picking-up Time | <65ms | ||
| Release Time | <65ms | ||
| Insulation Resistance | >1000MΩ(500VDC) | ||
Cautions of Latching Relay:
1.Tips of relay’s input
(one)Polarity-Make sure you check the polarity inside of our specialized specification, if single coil then”+ -” or “- +”are wonderful,
you can modify it by one pulse.If double coil then it really is necessary to confirm “-+-” or “+-+”ahead of leaving the our factory.
(2)Driving-Make sure you energize the relay at our suggest pulse width, rated voltage for reliable performance, if 1.5
times or two instances of worth or reduce driving problem plz confirm with our engineer.
(3)Relays’contact position may possibly be modified throughout transportation or set up due to affect of external pressure,
therefore you should reset to the necessary status.
2.Ideas of relay’s output
(1)When picking the relay with difficult link,remember to avoid the exterior pressure on load terminals during or after
the set up.
(two)When the relay will be related with screw or bolts to the relays’ terminals, plz make sure your link is
mounted and avert relay from damages or other protection issues owing to temp. Rise..
(three)The sampling signal wires of merchandise are restricted, please do not pull or torque during installation.
